OBSCURE OCTOPUS

FTC disclosure (16 CFR 255.5). Vendor buttons and product links on this page go through /go/ and are affiliate links. Obscure Octopus LLC may earn a commission if you buy, at no extra cost to you. A commission or a free review unit is a material connection. This notice sits here, next to the links, not only in the footer. Writeups are original bench notes.

As an Amazon Associate I earn from qualifying purchases.

Waveshare ESP32-P4 7B as a bike panel

10 Nov 2026 · original hardware writeup

The panel is the ESP32-P4-WIFI6-Touch-LCD-7B rev 1.1. ESP32-P4 rev v3.2, 32 MB PSRAM, 32 MB flash, 1024×600 touch. Wireless is an ESP32-C6-MINI-1 over SDIO (ESP-Hosted). Toolchain we use is ESP-IDF 5.5.4, flash on /dev/ttyACM0 at 460800.

K.A.S.H. bike firmware talks ISO-9141 on P4 UART1, GPIO4 TX / GPIO5 RX, through an off-board transceiver. The corner C6 UART0 header is the coprocessor download port. Do not put SDS there.

TWAI pins exist (TX GPIO22 / RX GPIO21) and RS485 (TX GPIO27 / RX GPIO26). The firmware we run does not open them. Onboard USB-UART is CH343P, separate from USB JTAG 303a:1001.

We mount the 7B upside down on the bike, so the LVGL rotation is 180°. Host-side Python still defaults to /dev/ttyUSB0 for the ISO111-E2, not a ttyC6 node.