FTC disclosure (16 CFR 255.5). Vendor buttons and product links on this page go through /go/ and are affiliate links. Obscure Octopus LLC may earn a commission if you buy, at no extra cost to you. A commission or a free review unit is a material connection. This notice sits here, next to the links, not only in the footer. Writeups are original bench notes.
As an Amazon Associate I earn from qualifying purchases.
Bench notes from Obscure Octopus LLC. Watch flash, C6 radar, Pi CAN, K-line isolation, parts lists. Amazon’s Associates rule of thumb is at least 10 original posts, generally within 60 days. These are those posts.
The board we actually flash: USB JTAG 303a:1001, Octopus OS 2.5.0, phone WiFi OTA after the first cable pass.
Everything on the bench for one Waveshare 2.06 watch, from cable to IDF, with the chips that are already on the PCB.
Two different boards, same VID:PID. How we tell them apart and why BOOT matters.
How we fuse a Seeed C6 with a 60 GHz module for presence, and why the C6 UART on the P4 7B is not this project.
KASH SxS on a Pi Zero 2 W: SPI0, GPIO25 IRQ, 12 MHz crystal, 120 ohm jumper off on a live vehicle.
Isolated USB-TTL, L9637, dealer coupler, MCP2515 hat. What is a K-line driver and what is not.
Why we picked a $11 isolated CH340 dongle, how the LEDs lie, and the L9637 wiring that actually talks.
7-inch 1024×600, P4 plus hosted C6, CH343P console, K-line on P4 UART1 not the C6 header.
Battery percent from 0xA4, gyro heading that drifts, no PPG. Sensors we have versus sensors the UI pretends.
12 MHz vs 8 MHz crystals, FD hat variant, and why HDMI touch fights GPIO25.