OBSCURE OCTOPUS

FTC disclosure (16 CFR 255.5). Vendor buttons and product links on this page go through /go/ and are affiliate links. Obscure Octopus LLC may earn a commission if you buy, at no extra cost to you. A commission or a free review unit is a material connection. This notice sits here, next to the links, not only in the footer. Writeups are original bench notes.

As an Amazon Associate I earn from qualifying purchases.

Espressif USB JTAG 303a:1001 on the watch and the 7B

15 Nov 2026 · original hardware writeup

Both the S3 watch and the ESP32-P4 7B panel show up as 303a:1001 USB JTAG/serial. Linux gives them /dev/ttyACM*. The watch on this bench is MAC B8:1F:3F:D8:28:B0. The 7B is E8:F6:0A:E8:BD:89.

If two cables are plugged in, do not guess the node. Read lsusb and the serial by-id path, or unplug one board. The companion USB flasher filters Espressif JTAG, so the picker can still show both.

Empty port picker usually means the ROM is not in download. Hold BOOT (GPIO0 on the watch), plug USB, then pick the port. Console on the watch is USB Serial JTAG in sdkconfig. The 7B also has a CH343P USB-UART that is a different device.

Baud we use for watch images is 921600. idf.py on the 7B often uses 460800. Mixing those numbers is a common “it connected then died” report.